September 26, 2011

Boat update 2

Alright, having some formatting issues again so I just moved on. It took a couple of weeks to get the first part done. Next I had to cut the plywood for the bunk. My boss at Perseverance used to build sailboats for a living so he showed me a really cool trick for getting complex curves. It involves a template of scrap wood and a block of hardwood. Attach template material to area you want to cut shape too. Then moving the block of wood along and making little lines on the end away from curve onto the template. Then take the template and attach it to the wood you want to cut, take the same block and line it up with your marks, then mark the wood to be cut on the opposite end of the block. Connect the marks into a line and cut. The more marks the more precise. It worked like a dream!
First piece in and second laying on top of it.
Both pieces in. The bed space is 4' 6" wide and removable by a few screws. The outside area of that are separate pieces of ply that were permanently attached and will hold our storage cabinets for cloths and such. I also attached sacrificial 2x4 blocks to the support beams for more surface area to land the plywood and to screw into. This should eliminate damage to the actual supports. I also boat a new LED light and switch for the storage area, switch seen just under 2x4 on upper right hand side of bulkhead. It lights when the light is on so we won't be accidentally lighting the area.
Next came the nice Oak end cap for the mattress to keep it from sliding off. This was attached to the 2x4 supports. Starting to really look like a bed! So excited!
Sarah spend the whole day and made a canvas cover for the foam we bought and we slid it in. Perfect! This shot show a little better the side boards that will be our storage cabinets for cloths etc. We will also leave about 4" on either side of the mattress just for some more room. On top of this foam will be a thin memory foam pad that came off the bed at home, she is tailoring that today.
Sorry, boat was rocking pretty good. This shot is too show the new lighting on the boat. I took out the old 70's style camper lights and replaced them all with marine grade LED lighting. It really made a huge difference. This cost me about $300 to completely install but so worth it. 3 ft one over the future kitchen table, 18" one over the galley, 1 foot light on bulkhead of v-berth door facing into the room with a switch right there, also 2 small directionally adjustable lights for the front of the v-berth to read by, and an under the shelf adjustable one for the cooking area. I also bought an 18 inch one for the head. It has clips that attach it to the wall and internal batteries that charge and hold for 3 hours. This allows me a light I can pop off the wall and take where its needed. Pretty cool. Sarah also bought us Christmas lights for a mellower lighting that I put up just after this shot.
Took a moment to enjoy the view. Our boat in the foreground and another Rawson right behind us and Mt. McGinnis in the back ground. Great view!
View from my back deck tonight as the sun began to set. Love it!
Well that is it for now, we are in full move and organize mode now and some final touches to the v-berth. Will post as soon as I can. We are so ready to be done with the move and settle in. Snow came down on the mountains to the shoulders last night and want to get on with making the boat ready for winter. Looking forward to enjoying our nice new bunk and warming next to the Dickenson stove.

No comments:

Post a Comment